BMW ONBOARD COMPUTER Manuel de service télécharger pdf (Page 93)

Slacken securing screw 1.

Push the two adapters 2 apart

until the telescopic forks fit

between them.

Use locating pins 3 to set the

front-wheel stand to the de-

sired height.

Centre the front-wheel stand

relative to the front wheel and

push it against the front axle.

Align the two adapters 2 so

that the telescopic forks are

securely seated.

Tighten securing screw 1.

Apply uniform pressure to push

the front-wheel stand down

and raise the motorcycle.

with centre stand

If the motorcycle is raised

too far the centre stand will

lift clear of the ground and the

motorcycle could topple to one

side.

When raising the motorcycle,

make sure that the centre stand

remains on the ground. If ne-

cessary, adjust the height of the

front-wheel stand.

Maintenance

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 147 148

Pas de commentaire

BMW ONBOARD COMPUTER Manuel de service Page 93