41
Central Information Display (CID)
Run the thick LVDS Cable from the CID hole down the left side vent area, around the back and into the dash
hole for the CCC. I installed the “protective strip” to keep it stock looking. I’m not sure what this does, but it
looks like a big foam wrap around each end of the LVDS cable. I doubt it has any shielding effect and in my
opinion is optional. In addition, you’ll have to make a small 4-wire harness for the CID. I built a harness from
a factory 12-pin connector, utilizing factory colored wiring to be consistent. I ran this harness from the back
of the CID hole, along the top-back of the dash support tube along with the factory dash harness, and down
along another harness to the JBE.
The harness I made was approx. 54” long. Here’s a picture:
Commentaires sur ces manuels