BMW X5 2005 Manuel du propriétaire télécharger pdf (Page 118)

118n

Integrated universal remote control

*

Programming

1 Memory buttons

2 Indicator lamp

Fixed-code hand-held transmitter

1. Switch on the ignition

2. For initial use: press both outer but-

tons 1 for approx. 20 seconds, main-

taining pressure until the indicator

lamp 2 starts to flash. The three

memory buttons 1 are cleared

3. Hold the original hand-held transmit-

ter at a distance of approx. 2 to 8 in/

5 to 20 cm from the memory but-

tons 1

The required distance between

the hand-held transmitter and

memory buttons 1 depends on the

530us247

relevant system of the original hand-

held transmitter used.<

4. Simultaneously press the transmit

button on the original hand-held

transmitter and the desired memory

button 1 of the integrated universal

remote control. Initially, the indicator

lamp 2 flashes slowly. Release both

buttons as soon as the indicator

lamp 2 flashes rapidly If the indicator

lamp 2 does not flash rapidly after

approx. 15 seconds, change the dis-

tance

5. To program other original hand-held

transmitters, repeat steps 3 and 4.

The corresponding memory button 1 is

now programmed with the signal of the

original hand-held transmitter.

You can operate the system when the

engine is running or when the ignition is

switched on.

If the system cannot be operated

after repeated programming,

check whether the original hand-held

transmitter uses an alternating-code

system. To do so, either read the

instructions of the original hand-held

transmitter or press and hold down the

programmed memory button 1 of the

integrated universal remote control.

If the indicator lamp 2 on the integrated

universal remote control flashes quickly

for a brief period and then remains lit up

for approx. two seconds, this indicates

that the original hand-held transmitter is

equipped with an alternating code. In

the case of an alternating-code system,

program the memory buttons 1 as

described at the section on alternating-

code hand-held transmitters.

If you have additional questions, please

consult your BMW Sports Activity Vehi-

cle center or call 1-800-355-3515.

You can also visit this website

www.bmwusa.com <

Alternating-code hand-held

transmitter

To program the integrated universal

remote control, consult the Owner's

Manuals for the equipment to be set.

You will find information there on the

possibilities for synchronization.

When programming alernating-code

hand-held transmitters, please observe

the following supplementary instruc-

tions:

Programming will be easier with

the aid of a second person.<

Online Edition for Part No. 01 41 0 158 701 - © 10/04 BMW AG

1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 199 200

Commentaires sur ces manuels

Pas de commentaire