Bmw 645Ci Coupe 2005 Manuel d'utilisateur télécharger pdf (Page 101)

Practical interior accessories

100

Practical interior accessories

Integrated universal remote

control*

The concept

The integrated universal remote control

replaces up to three different hand-held trans-

mitters for various items of radio-controlled

equipment such as door openers and house

alarm systems. The integrated universal remote

control registers and stores signals from the

original hand-held transmitters.

The signal of an original hand-held transmitter

can be programmed into one of the three mem-

ory buttons 1. Then the respective device can

be actuated using the memory button 1 pro-

grammed for its use when the ignition key is in

position 2. The LED 2 flashes to confirm trans-

mission of the signal.

If you sell your vehicle one day, delete the saved

programs beforehand for your own security,

refer to page 101.

To prevent possible damage or injury,

before programming or using the inte-

grated universal remote control, always inspect

the immediate area to make certain that no peo-

ple, animals or objects are within the travel

range of the device. Also comply with the safety

precautions of the original hand-held transmit-

ter.<

Checking compatibility

If you see this symbol on the packaging

or in the manual supplied with the orig-

inal hand-held transmitter, it is safe to

assume that it is compatible with the integrated

universal remote control.

If you have additional questions, please consult

your BMW center or call 1-800-355-3515.

You can also visit these websites:

www.bmwusa.com or

www.homelink.com.

HomeLink is a registered trademark owned by

Johnson Controls, Inc.

Programming

1 Memory buttons

2 LED

Fixed-code hand-held transmitters

1. Ignition key in position 2.

2. When using for the first time: press both

outer buttons 1 for approx. 20 seconds,

maintaining pressure until the LED 2 starts

to flash. The three memory buttons 1 are

cleared.

3. Hold the original hand-held transmitter at a

distance of approx. 2 in/5 cm to 8 in/20 cm

to the memory buttons 1.

The required distance between the

hand-held transmitter and the mem-

ory buttons 1 depends on the respective

system of the original hand-held transmitter

used.<

4. Simultaneously press the transmit button

on the original hand-held transmitter and

the desired memory button 1 on the inte-

grated universal remote control. Initially, the

LED 2 flashes slowly. Release both buttons

as soon as the LED 2 flashes rapidly. If the

LED 2 does not flash rapidly after approx.

15 seconds, change the distance.

5. To program other original hand-held trans-

mitters, repeat steps 3 and 4.

The corresponding memory button 1 is now

programmed with the signal of the original

hand-held transmitter.

Online Edition for Part-No. 01 41 0 158 445 - © 09/04 BMW AG

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 216 217

Commentaires sur ces manuels

Pas de commentaire